Renogy 200-Watt 12-Volt Flexible Monocrystalline Solar Panel for Vans, Curved Roofs & Marine
Off-Grid Power That Goes Where Rigid Panels Can't: Ultra-Thin, Ultra-Light, Bendable to 240 Degrees
Not every roof is flat. The Renogy 200-Watt 12-Volt Flexible Monocrystalline Solar Panel bends up to 240 degrees to follow the curved rooflines, pop-tops, and cabin tops where rigid panels simply can't mount, bringing up to 1000 watt-hours of daily power (based on around 5 hours of direct sunlight) to van, RV, and marine builds.
At 63.2 x 29.4 inches and barely a tenth of an inch thick, it weighs just 10.8 lbs, roughly 50% lighter than a comparable rigid panel. The slim profile all but disappears on a van roof, which makes it a favorite for stealth builds, and the low weight matters on pop-tops, boat decks, and anywhere every pound counts.
It's tougher than it looks, too. Half-cut PERC cells and bypass diodes keep power flowing through hotspots and accidental shading, an ETFE surface layer boosts light transmittance while shrugging off weather and UV, and a reinforced composite backing adds strength without giving up flexibility.
Key Features
✔ Bends Up to 240 Degrees
Conforms to curved van roofs, Airstream trailers, boat cabin tops, and other uneven surfaces where a rigid panel would never sit flush, opening up mounting real estate most solar setups can't use.
✔ Up to 1000Wh of Power Per Day
With around 5 hours of direct sunlight, this 200W panel can generate up to 1000 watt-hours daily, real power for fridges, fans, lighting, and device charging on off-grid trips.
✔ Ultra-Light, Ultra-Thin Profile
At 10.8 lbs and just 0.1 inches thick, it's roughly 50% lighter than rigid panels, keeps weight off pop-tops and roof decks, and sits so low it's nearly invisible from the ground.
✔ Half-Cut Cells & Bypass Diodes
Half-cut PERC cell technology reduces internal resistance for higher output, resists hotspot damage, and keeps the panel producing through accidental shading from branches, racks, or rooftop gear.
✔ ETFE Surface with 9-Busbar Cells
A durable ETFE top layer improves sunlight transmittance and stands up to years of weather and UV exposure, while 9 busbars per cell enhance conversion efficiency and long-term reliability.
✔ Built to Endure Harsh Weather
Rated for 5400Pa snow loads (~113 psf) and 2400Pa wind loads (~50 psf), with an IP68 junction box, IP67 waterproof connectors, and a reinforced composite backing layer for added durability.
✔ Easy, Low-Profile Installation
Reinforced mounting holes and MC4-compatible connectors make wiring and mounting straightforward, and at under 11 lbs the panel can also be bonded flat to the roof with adhesive for a clean, drill-free install with no racking required.
Built for Curved Roofs, Stealth Builds & Life on the Water
If a rigid panel won't fit your surface, this is the panel that will. It's ideal for:
- Sprinter, Ford Transit & RAM ProMaster van conversions with curved rooflines
- Stealth and low-profile camper builds
- Airstreams and curved-roof travel trailers
- Marine, sailboat & boat installations
- Pop-top campers, rooftop tents & off-grid structures
- Lightweight builds where every pound matters
System Compatibility
12V Off-Grid Battery Systems (Van | RV | Marine | Cabin); wire two in series for 24V banks Charge Controller: PWM or MPPT compatible (MPPT recommended, sized for the panel's 10A+ output current) Connectors: IP67 waterproof solar connectors (MC4-compatible) with 12 AWG output cables Mounting: Reinforced mounting holes or adhesive bonding | No racking required
Specs & Dimensions
Rated Power (Pmax at STC): 200W Open Circuit Voltage (Voc): 23.9V Short Circuit Current (Isc): 10.74A Optimum Operating Voltage (Vmp): 20.1V Optimum Operating Current (Imp): 10.02A Maximum System Voltage: 600VDC Maximum Series Fuse Rating: 15A Module Efficiency: 16.7% Cell Type: Half-cut monocrystalline, 72 cells Maximum Bend Angle: 240 degrees Operating Temperature: -40°F to 176°F (-40°C to 80°C) Dimensions: 63.2 x 29.4 x 0.1 in (1605 x 748 x 3 mm) Weight: 10.8 lbs (4.9 kg) Surface Material: ETFE Junction Box: IP68 rated Certifications: CE, ISO9001 Warranty: 5-Year Material & Workmanship Warranty | 5-Year 90% Output Warranty
Why Choose the Renogy 200W Flexible Solar Panel?
- Mounts on curved and uneven surfaces where rigid panels can't
- Up to 1000Wh of daily output from a single panel
- Roughly 50% lighter than rigid panels at just 10.8 lbs
- Keeps producing through partial shade thanks to half-cut cells and bypass diodes
- Near-invisible 0.1-inch profile for stealth and low-drag builds
- Backed by Renogy, one of the most trusted names in van and RV solar
The Renogy 200-Watt 12-Volt Flexible Monocrystalline Solar Panel puts serious off-grid power on surfaces rigid panels can't touch, pairing a 240-degree bend and a featherweight 10.8 lb build with weatherproof, shade-resistant construction for your van, trailer, or boat. Ships free to the lower 48 states.
